Sensor Swab ULTRA is the professional standard for cleaning CCD and CMOS sensors, along with other delicate or hard-to-reach optical and imaging surfaces. Each swab is manufactured and sealed in a clean room for absolute purity, and is more absorbent than a standard swab without shedding or leaving fibres behind. The redesigned ULTRA head adds pointed end points that reach into the gap between sensor and baffle where debris collects, a textured surface that picks up more contamination per pass, welded seams that hold the fabric stable, and a channelled handle for better control. Sold individually sealed and available in four widths to match your sensor.
Which type do I need?
Type 1 (20mm) suits most full-frame sensors, Type 2 (17mm) suits APS-C and crop sensors, Type 3 (24mm) suits medium format, and Type 4 (33mm) covers the largest sensors including large format and cinema bodies. Getting the width right matters — too narrow and you’ll leave streaks down the sides, too wide and it won’t sit properly in the sensor well.
How to use
Check your camera manual for how to expose the sensor, make sure the battery is fully charged, and blow off any loose dust with a blower or brush first. Apply a few drops of Eclipse or Aeroclipse cleaning fluid to the swab, then drag it firmly across the sensor in one direction using one side. Repeat in the opposite direction using the clean side. Release the shutter and refit your lens.
Aeroclipse or Eclipse?
Aeroclipse is the non-flammable option, with the same cleaning power as Eclipse but considerably less methanol — the one to choose if you fly with your kit or want fewer shipping restrictions. Eclipse is the purest formula and the long-standing professional choice, and the Eclipse version of this kit is available if that’s your preference. Both dry fast and leave no residue.
Please note: the pointed tips feel sharp but are designed not to scratch — they’re there to grab debris from the sensor edge. Leave each swab sealed in its bag until the moment you use it, since airborne dirt picked up beforehand is exactly what causes scratches, and discard it immediately afterwards. Never re-use a swab; start a fresh one if a second pass is needed. Zoom lenses and bellows draw in more contamination, so expect to clean more often if you use them.
Features & Benefits
- Pointed end points reach the corners and sensor-to-baffle gap
- Textured surface collects more debris in a single pass
- Clean-room manufactured and individually sealed for maximum purity
- Welded seams keep the swab fabric stable under pressure
- Channelled handle for a more secure grip
- Highly absorbent — no shedding, no fibres left behind
- Safe on CCD and CMOS sensors and other delicate optical surfaces
- Four widths available: 17mm, 20mm, 24mm and 33mm
Directions for use:
- Blow off loose dust and expose the sensor per your camera manual
- Remove the swab from its sealed bag only when ready to use
- Apply cleaning fluid, then drag firmly across the sensor in one direction
- Repeat in the opposite direction with the clean side
- Discard the swab after use and refit your lens


























